![]() ![]() Second thing is when you copy it to the Sign Blazer directory it does nothing. if this is what happens you say yes it overwrites the file and you're good to go. First it might tell you that the file already exists and ask if you want to overwrite it. Once you do that it's going to do one of two things. you'll have to unzip the file with winrar or winzip once you have it unzipped it more than likely the unzipped file has to be put into the Sign Blazer directory. I'm not familiar with Sign Blazer but I have used patches in the past. This is why I suggested Signblazer ALL Cutter version, It does have his cutter on it. read his earlier posts., unless you can figure out something else to try. The CE3000, does not show up in his Flexisignpro7. LOL, we have already gone thru this with the Legacy driver from Graphtec on an earlier post. ![]() From the sound of what you describe it is set to "Hold In List" Now for the "holding for 3 seconds and then doing nnothing" When you click on the Plot Cut Icon and the Plot Cut pop up you will notice a drop down menu that says "send Mode" click the drop down arrow and choose "Send Now". Next scroll down to CE 3000 series and click on it. Here is a link to the Graphtec support after you get there click on Cutting Plotters, then scroll to the bottom on the right hand side to Discontinued / Legacy Cutting Plotters and click on it. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |